NFPS / Private Your STB is damaged. Call the provider.

[chocolatgreg]

On MAG254....

All my settings are correct; it has loaded previously without issue; I changed nothing and this is the error I am now getting when it tries to load. Can somebody please tell me what the problem is?

 

[BIO]

Ethernet working? And is this a mag and not an emulator?

 

[Marley]

yea have seen that when using emulator

 

[chocolatgreg]

It is a physical MAG254 box, not emulator. Ethernet is working and I did a firmware update from infomir. Still have the issue

 

[Tony47nv]

Did a factory flash and all is good had same message (stb is damaged call your provider) after i did some editing to settings. Just reboot and press 3 dot button and click nand and went back to factory settings

 

[danemer]

Got this same message a couple of times myself during setup.
I (manually) went back to older version of software "update" - and then back to newer update right after that.
I suspect (but am unsure) that an error made while typing your server url may be the cause of this issue.
I also did some editing to settings - especially those concerning the TV "aspect" feature.
My MAG 254 won't work with my DVR and older TV unless I use the NTSC setting.
Good luck!

 

[Bkman2020]

Means the mac address on your device has been used or could be corrupted.

 

[jillianl]

you need to change the last 3 digits of the mac address in the profile settings.

 

[balra]

i need gactory firmware for mag 250 if any on ehave please help me, thanks

 

[alphablondy]

i need gactory firmware for mag 250 if any on ehave please help me, thanks

balra your hijacking this thread. I see its your first post, so here is the info at this link http://iptvtalk.net/showthread.php?102-How-to-reset-mag250-to-factory-setting. next time please start your own post

 

[lyla99]

hi got same message so if i change numbers on mac address can i change them to anything really new at all this and would like to thank you for the help and the good reading great site thank you

 

[greg]

factory reset box first then set back up with mag 254 setup guide you cannot change mac address you link mac address to your route mac is on the bottom of the box link that one to your route

 

[frostycold]

hi got same message so if i change numbers on mac address can i change them to anything really new at all this and would like to thank you for the help and the good reading great site thank you

What are you using to view? Mag, Avov, Emulator?

 

[lyla99]

followed post 5 and all is good now thanks

 

[Tom Matthews]

Did a factory flash and all is good had same message (stb is damaged call your provider) after i did some editing to settings. Just reboot and press 3 dot button and click nand and went back to factory settings

Hey man, I am new at this...what is a factory flash? Thank you

 

[K00lKatT]

he means a fac restore or restore fac settings, a reset..

 

[jmkodi]

Check your mac and make sure nobody is using it. If your mac is already subscribed to service, you may want to contact support and short it out.

 

[Marley]

if its mac it would tell him that when he tried to add the address from here http://iptvtalk.net/showthread.php?2930-NFPS-Rocket-CUSTOMERS-IMPORTANT-MAC-IPTV-INFO

 

[Marley]

most of time when get that you did something wrong in setting it up

 

[Bkman2020]

A Carpenter always measures 3 times before he cuts