Tftp load

[poke chop]

Here is what happen, I have two boxes on one them I turned it on and it had a black screem, so I did some reading and end up doing the factory reset, when the box was rebooted it went to Tftp load and now stuck in that mode. I tried to go back into dose mode but nothing happen,PS what can I do to fix this, thanks in advance.

 

[greg]

go in to bios change boot mode to nand are nand2 save end exit

 

[tallman]

to get in there you have to hold down the menu key and then plug the box in

 

[poke chop]

That's what I did to do the factory reset.But after I tried to go back into bios by holding the menu and unplug and repluging,that's when it went to Tftp Load and got stuck there and now it want let me back into bios just reboot back to Tftp load everytime I try to go to bios.

 

[K00lKatT]

it will go to BIOS menu if you do it properly...

 

[working13]

did you get true after resetting to get your box working ? black screen gone ?

 

[poke chop]

I hold the menu down, after unplugging held down while replugging and it boot right back to Tftp load, doing it over and over again and the same thing happen everytime.

 

[poke chop]

Hey guys check this out, after trying and retrying with the menu key I tried it with I key and worked don't ask me how but it did thanks guys.

 

[working13]

the black screen gone are able to watch tv back ?

 

[poke chop]

TV back had put all info back in, but yes tv is back you guys are great thanks again.

 

[csm101]

I'm in the same boat. Stuck on TFTP Load.

1) How long does the process take
2) I can of back into the settings and confirm its set for NAND2

 

[greg]

unplug mag 254 hold menu button on remote plug mag back in to enter bios change boot mode nand are nand2 exit and save