• The Sticky threads for the Dreamlink T3 and the Formuler Z8 devices can be shared.
    These devices are exact same devices, all except their name and gift boxing.
  • I see people with this MAC issue often.
    The thing is that the service wants the MAC of the IPTV application that the device is using to connect to the service and not the actual device's MAC
    The IPTV application would be the DOL or MOL application and it's MAC will always starts with 00:1a:79
    If you noticed that the device's MAC and the IPTV MAC (DOL or MOL) have the same last 6 digits, but the first 6 are different. The first six is what tells the server to recognize the MAC. It will not recognize the device's MAC since it does not begin with 00:1a:79 ... nor does the device itself connect to the service, the DOL or MOL does.

New T3 Possible DOA

O

Ouch407

New member
Jan 28, 2021
9
0
0
yes i do
#1
Received a new T3 today which was a replacement for an older model. I think it may be DOA. I plugged it in and the light was flashing green/red and then went solid green. I tried on two different TVs with different HDMI cables and signal not detected. I believe there is no output from the HDMI on the T3.
I do have a T1,T1 plus, T2 and a T3 and have never experienced something like this before. Typically it come right on and follow the set up instructions.

Any suggestion or experience in correcting?

Thanks
 
#2
certainly sounds like a hdmi/power issue, yea.
So how to interupt the power to perhaps kick into gear?
Maybe insert a USB device and then power up the T3.. if no change unplug the USB while power is still on and reinsert it.
Do same with HDMI if no changes.
If still no change then you could try a Manual reset.

But one question. Do you still have the correct power supply being used on tat T3 ?
The T3 uses the 12V adapter as apposed to other Dreamlink models, which use the 5v adapter.


Manual Factory reset

-Please take a memo of your important data or do backup using backup and restore tool before the factory reset
-Remove power from the device
-While repeatedly pressing the RED colored button on the remote, insert power into the device at same time.
-Keep pressing the button repeatedly, butdon't hold it down.
-The LED on the front of the device will flash quickly alternating from greet to red. Stop pressing the RED button
-While the status LED is flashing red and green, press 1 on the remote
-The device will initiate the factory reset procedure
-Do not remove power to the device.
-Wait until the reset procedure is completed
-The reset procedure is complete when you see the Setup Assistant on the TV screen
 
Last edited:
#4
Thanks for the quick reply and the suggestions but no luck. Yes the correct power supply used. Just seems that there is no video output.
i have reached out to the seller for warranty claim

Thanks again.
 
You must log in or register to reply here.
Top Bottom
Back
Menu