necessary to remove and re attach power cord to start loading?

[aaronep]

I have a mag 254 that is attached without wire to my new tv with multiple hdmi ports. when the tv is turned on and I switch to the hdmi port that is connected to the mag 254 receiver , the screen displays "no signal" message. I then depress the red on/off button in the upper right hand corner of the iptv remote and nothing changes. still no signal. I then have to remove the power cable from the back of the iptv receiver and then after 3 seconds, re insert it. It is only then that the iptv receiver starts normal loading and the receiver brings in desired signals.

Is this normal, or is it a malfunction of either the iptv receiver or the remote? Should I be doing something differently?


Best, Aaron

 

[Kimbo]

i had some issues like that but i had to give it a couple of minutes and then i would come on. If not check the resolution on the box.

 

[aaronep]

Dear Laser915: thank you for your quick reply. I did try suggestion to wait more than a couple of minutes but nothing different happened.
When you say resolution on the box, does this mean I should reduce the resolution (less pixels), or something else. Best, Aaron

PS: anyone reading this have additional suggestions, please join in!

 

[EPAPRESS]

...
Is this normal, or is it a malfunction of either the iptv receiver or the remote? Should I be doing something differently?

Best, Aaron

Yesterday I connected the powercord and none of my boxes (MAG 254, MAG 275, AuraHD Plus, AuraHD International SE) was sending any signal to the HDMI 3 input of my Samsung HDTV!

I tried all:

- Changing of HDMI Input, no signal
- SAT Receiver at HDMI 3 worked

So I only connected again the 12V power to the MAG boxes and all boxes are showing again signals, like always!

I was happy, but that "failure" was tricky to solve...

Manfred

 

[Marley]

it takes my tv like two times to find the right mode

 

[dambikr]

I have the same problem but I found that if you turn on the Mag first using the regular on/off button it will go on and then I turn the tv on and everything works....at least for me it did.